|
Sofflow Bidet Installation Instructions
 Step
1
Lift and remove the existing toilet seat by removing the
screws that hold it.
 Step
2
Install the "HOLDING PLASTIC PLATES" to the
Bidet back area (rear). Make sure the plates can slide in or out about one inch
in order to adjust them to the toilet installation area.
 Step
3
By holding the Sofflow Bidet in the air, obtain the
correct measurement by aligning the screws to the two toilet holes. Make sure
that the plastic screws coincide with the toilet holes.
 Step
4
Attach and tighten the "HOLDING PLASTIC PLATES" to
the selected position by using the metal screws that are temporarily holding
them.
 Step
5
Place the Sofflow Bidet on top of the toilet. Insert the
plastic screws in the toilet holes and proceed to tighten the plastic screws and
knob using the included tool. BE CAREFUL NOT TO OVER-TIGHTEN THEM.
 Step
6a
Close the toilet water supply valve.
 Step
6b
Flush the toilet to remove the water from the tank.
 Step
6c
Disconnect the hose that connects the water supply to the
toilet tank.
 Step
6d Connect the "T-Valve" 7/8" connection to
the toilet tank.
 Step
6e
Reconnect the water supply hose removed in step 6c to the
"T-Valve".
 Step
6f
Use the enclosed white transparent hose and attach one
end to the push-in valve. Make sure to twist the hose about 30 degrees while
pushing it in. This technique will avoid water leakage.
 Step
6g
Repeat the same step with the other end of the hose by
inserting it into the toilet seat cold water valve (the blue one).
Step 7 (OPTIONAL) How To Connect Hot Water.
A) Close the sink hot water valve.
B) Disconnect the hot water hose from the valve.
C) Install the "T-Valve" into the hot water connection.
D) Same as Step 6f from above
E) Remove the plug from the Push-In (RED) mixer valve in
the Sofflow Bidet toilet seat.
F) Connect the other end of the transparent hose to the Sofflow
Bidet toilet seat Push-In (RED) Mixer-Valve
WARNING - If hot water is not needed , do not remove the plug
from the Sofflow Bidet toilet seat Push-In (RED) Mixer-Valve
Recommendations for the proper use and maintenance of the Sofflow Bidet:
1. The Sofflow Bidet toilet seat should be left in normal position
over the toilet bowl.
2. Do not beat or hit the Sofflow Bidet toilet seat or cover
against the toilet tank.
3. Clean with soft cloth or sponge and detergent or sanitizing
cleanser.
| 
Washington
Trade International Inc.
